Bob,rb service lytle tx. you probably need to clean with cotton swab and windex the tops of the sensors you soldered. Even may have to change one of them check the one for reel motion if this has 3 of them they are interchangable if u need to experiment clean any prisoms on unit this may help - should fix. let me know . megapicker@xxxxxxxxxx ----- Original Message ----- From: <MagLfixIt4ya@xxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Tuesday, May 14, 2002 2:22 PM Subject: [TechAssist] VCR, JVC HRS7500U shuts down > > Hello all, it powers on then shuts off in about 10sec and the display flashes > "Auto," heads rotate, has IR and will except a cassette, however to eject it > takes several tries as it powers off before the cycle is complete, did solder > all sensors and the IR diode, any help is appreciated, also if anyone has a > cross model that might be helpful as well, thanks! > > Don@ Affordable Electronics > 153 Garfield Place > Brooklyn NY 11215 > 718-788-0384 > 718-788-2326 fax > > ------------------------------------------ > To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html > ------------------------------------------ > ***NEW*** Tips Added Instantly!!!*** > Submit Repair Tips here: > http://www.tech-assist.org/secure/tip/ ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/