c4401,2 cr4401,2 Peggs At 12:04 PM 3/9/04, Intrepid Video Support wrote: >Found resonator had electrolyte all around it...cleaned board, replaced >resonator and two caps right >there...now standby is fine, but of course this *&^*^* set still shuts down. >Voltage on pin 16 of U4101 is 10.4 v...stand by and when I press power >doesn't change...pin 15 is the >same.. >I've been all over the troubleshooting guides, changed ALL the caps in the >regulator circuit, CR4118 >changed and checked all the resistors... >On me last breath...I appreciate the many responses and will send my thank >yous after I get this fixed... >Thanks. > > >Jeff Dougherty >Intrepid Video TV/VCR >263 S Front St >Steelton PA 17113 >fax...717-564-4952 >www.intrepid-video.com www.tech-repair.net > >----- Original Message ----- >From: "Intrepid Video Support" <support@xxxxxxxxxxxxxxxxxx> > >Still working on this, can not figure out why it is shutting down as HV >builds. >Would a defective vertical section cause this set to shut down? >REG B+ is 170 in standby, drops to 162 when I press power..is this normal >on this set? >Schematic shows Reg B+ <72-A>, Not sure what that means. >I've repaired many of these with a splitter, flyback or replacing the >parts in the power supply. >I've done all this and set still shuts. I've replaced all the caps, the >boxed caps in front of the HOT, >CR4118(tested OK), U4101, Q4101, Q4401..and all the caps. Checked all the >diodes and resistors and can >find no problems. >I'm running out of time on this one....Does anyone have any idea what I >may have missed? >Thank you. > >Jeff Dougherty > >----------------------------------------------------------------------------- >Lost Password: >http://www.tech-assist.org and select "Login Problems?". >Email Archives: >//www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/