If the convergence ic's areon the power supply bd on this set,then check and see if there is a fuse F850 and a connector labeled P812.If they are there,then put the module back in the set,remove F850 and connector P812.Now power set up and see if you get a pix ..Keep in mind that the pix be will out of convergence, so don't let it run too long. If you do get a pix,then just replace both stk's and you should be ok. Mando Birdie's TV & Electronics Casa Grande, AZ TV Man wrote: > Set is dead red light blinking. I'm thinking the conv. ICs the big STKs. Is > there a way of testing or checking them out somehow with only the power > supply board? I have the P/S board at my house, and I'd like to make sure it > was that before bringing it back.Thanks, Dave > ============================================ > TV Man > P.O.Box 654 > Inverness, Fl. 34451 > ================================= > ***************************************************************************** > Classifieds! Buy or Sell! > http://sell.tech-assist.org > The Tech Address Book: > http://www.tech-assist.org/secure/tip/contact.htm > Add a Repair Tip Here, or Change/Remove your Email Address: > http://www.tech-assist.org/secure/tip/main.htm > Lost Password: > http://www.tech-assist.org and select "Lost your Login Info?". > Email Archives: > //www.freelists.org/archives/techassist/ ***************************************************************************** Classifieds! Buy or Sell! http://sell.tech-assist.org The Tech Address Book: http://www.tech-assist.org/secure/tip/contact.htm Add a Repair Tip Here, or Change/Remove your Email Address: http://www.tech-assist.org/secure/tip/main.htm Lost Password: http://www.tech-assist.org and select "Lost your Login Info?". Email Archives: //www.freelists.org/archives/techassist/