Jeff, The relay latch at plug-in is because the unit was powered on when failed. When you remove F470, do you have proper +125 volts on one side of fuse holder? If so regulator circuit is OK. Try checking Q471 & Q472 for leakage. Robert tvservice@xxxxxxxxxxxxxxxxxxx H & H Electronics Inc ----- Original Message ----- From: "Lyles Tv" <tech@xxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Thursday, October 10, 2002 3:29 PM Subject: [TechAssist] Toshiba CE36G18 TAC 9708 dead, 170v B+, relay latches > CE36G18 TAC9708 dead. Relay latches at plug in. 170v B+ 170V on pin 1 of Q801 STRZ5141B all output voltages of regulator pulsing. I've tried isolating vertical and audio. I replaced Q883, a 6 volt regulator. I do have the schematic, but it isn't helping. Any ideas would be greatly appreciated. > > Jeff Farnsworth > Lyles TV and Appliance > 17 S Washington St > Elkhorn, Wi. 53121 > ph 262-723-3477 > fax 262-723-3658 > tech@xxxxxxxxxxx > yyyyy > > ------------------------------------------ > To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html > To CHANGE your email address, click here: > http://www.techassist.net/forms/change.html > ------------------------------------------ > ***NEW*** Tips Added Instantly!!!*** > Submit Repair Tips here: > http://www.tech-assist.org/secure/tip/ > ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/