Ralph, Could you post this procedure with the model number? This may come in handy if someone is looking for this information in the future. Jeff FAX 717-564-4952 Jeff Dougherty Intrepid Video & Electronics 501 Luther Rd Harrisburg, PA 17111 717-909-8844 VCR tips, electronics info & general interest. www.intrepid-video.com www.tech-repair.net www.thetoolcaddy.com ----- Original Message ----- From: "Ralph Dorsey" <Merlin-Wizard@xxxxxxxxxxxxxxxx> Cc: <premtech@xxxxxxxxxxxxxx>; <techassist@xxxxxxxxxxxxx> Sent: Wednesday, February 27, 2002 5:25 AM Subject: [TechAssist] Thanx bill for service code site > > That was agood site thankx. I was able to enter the service mode by > following the remote control entering opttion. I knew about the sorting > pins on test jack in direct view models. But this 6 month old projection > set doesn't seem to have one of those. I assume that means your suppose > to use the remote option only because you wouldn't have to take the back > off. I don't have any on set values though for the deflection settins, > but i wrote done all the vales before i started. I do have control over > the adjustments so i might give it a try before getting the manual. (I > only have the light box right now). But thankx again. > > ------------------------------------------ > Make your TechAssist database better! > Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ > ------------------------------------------ > To UNSUBSCRIBE your email address, click here: > mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe > Or send a BLANK email with unsubscribe in the > SUBJECT field to the address above. > ------------------------------------------ Make your TechAssist database better! Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ ------------------------------------------ To UNSUBSCRIBE your email address, click here: mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe Or send a BLANK email with unsubscribe in the SUBJECT field to the address above.