does anyone have the reset circuit for this tv/vcr. al marquardt ampm@xxxxxxx ----- Original Message ----- From: "al m" <ampm@xxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Sunday, October 20, 2002 1:11 PM Subject: [TechAssist] TVSB1320 TV/VCR Zenith > > Thought I had this one fixed good thing the customer didn't pick it up. Can > anyone tell me if this units power supply is supposed to run all the time at > full power.The only time it will turn on after being plugged in is when it > runs at full power. Sometimes when you plug it in the voltages are low and > it won't turn on.Not sure where to go without scat. I thought it was the 5V > regulator so I changed it but now it's doing the same thing after a couple > days.Freeze spray doesn't help.After turning on the first time it turns on > all the time at reduced power.Could be a reset problem maybe. Any > suggestions. > al marquardt > ampm@xxxxxxx > > > > ------------------------------------------ > To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html > To CHANGE your email address, click here: > http://www.techassist.net/forms/change.html > ------------------------------------------ > ***NEW*** Tips Added Instantly!!!*** > Submit Repair Tips here: > http://www.tech-assist.org/secure/tip/ > ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/