Jeff I just had one like that but a different model # check the resistors on the CRT board. I thought for sure bad CRT but I checked it and checked good. The resisters were open. Al Marquardt ampm@xxxxxxx Al Marquardt Electronic Repair 206 W Main Girardville Pa. 17935 ----- Original Message ----- From: "Intrepid Video Support" <support@xxxxxxxxxxxxxxxxxx> To: "Techassist" <techassist@xxxxxxxxxxxxx> Sent: Friday, September 17, 2004 10:01 PM Subject: [TechAssist] TA Zenith SR2552S 9-1558..colors messed up...not CRT. > > > When I first saw the problem, I rejuvenated the CRT..emissions were low on > red and blue. Rejuvenation was > successful and emissions look good. Picture brighter, but wrong colors. > Where I should have blue, it is green. > I checked every resistor on the CRT board..some I had to pull, they check > fine. > Collect on blue transistor is over 200vdc. The other transistors are > considerable lower. > Does anyone have any idea where I can go from here without a schematic? Is > the problem the video proc. IC? > Thank you, > Jeff > -- > Intrepid Video TV/VCR Repair > 263 S Front St, Steelton PA 17113 > 717-939-7708; (F) 717-564-4952 > www.intrepid-video.com www.tech-repair.net > > > ----------------------------------------------------------------------------- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ > > ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/