Sounds like there is no E/W parabolic wave form from the Jungle IC. Are you getting the necessary E/W drive signal? It should be about 1.5 volts PP at 16.6 milliseconds. Dennis "G.N.Arrivas" wrote: > Pincushion Distortion: KV32XBR55 > check for open R537 feedback loop from Q505 to IC531 > > Since you have replace most parts that usually fails on the A board. Check > the feed back loop above. > > G.N.Arrivas, CET, Pittsburg, CA > Tel/Fax: (925) 432-2057 > Arrivas Enterprises > http://www.arrivasenterprises.com > > Electronics Repair Help > http://www.etechhelponline.com > (Viewed by technicians in 60-plus countries worldwide) > > Tax Help Online: > http://www.itaxhelponline.com > > ----- Original Message ----- > From: <tvdoctors@xxxxxxxxxxxxx> > To: <techassist@xxxxxxxxxxxxx> > Sent: Tuesday, November 13, 2001 10:41 AM > Subject: [TechAssist] Still unsolved mystory: > > > SONY KV32XBR55: Replaced Q505(shorted), R571(open), IC531, > L501(recommended replaced), and checked and resoldered D512(Checked Ok). No > schematic. Still has bowed sides. Pincushion and Horiz.Size in service menu > wont adjust (numbers change), all other adjustments work. If I jump across > L501, I get almost full scan but I can still see that pincushion is out of > alignment. Any thoughts to getting this set out of here would be greatly > appreciated, Thanks, Neil > > > > > > > > TV Doctors 108 W. Main St. Monroe,Wa. 98272 360-794-6469 > > > > ***************************************** > > Help make your TechAssist online repair tips > > database better! Submit your fixes here: > > http://www.circuitwork.com/techassist/tip/#tips > > ***************************************** > > To UNSUBSCRIBE write to: > > techassist-request@xxxxxxxxxxxxx > > with unsubscribe in the subject line. > > > > ***************************************** > Help make your TechAssist online repair tips > database better! Submit your fixes here: > http://www.circuitwork.com/techassist/tip/#tips > ***************************************** > To UNSUBSCRIBE write to: > techassist-request@xxxxxxxxxxxxx > with unsubscribe in the subject line. ***************************************** Help make your TechAssist online repair tips database better! Submit your fixes here: http://www.circuitwork.com/techassist/tip/#tips ***************************************** To UNSUBSCRIBE write to: techassist-request@xxxxxxxxxxxxx with unsubscribe in the subject line.