tighten chassis ground screws Peggs At 11:25 AM 1/28/03 -0500, David Lessard wrote: > >Gentlemen, > >I finally got around to looking at this unit again. It will power-up, but >most of the time it goes right in to "PROTECTION" mode, occasionally it will >work for 20 - 30 seconds, then "PROTECTION" mode. When it does work, I >notice the audio output flucuates a bit, sort of like a low frequency >fluttering sound (+50 & -50 are stable during this). Are there any common >problems with this unit? What causes protection to activate? I know nothing >about this particular unit, any help would be greatly appreciated. Would any >member have a schematic please? Thanks. > >David Lessard >mrfixit@xxxxxxxxxxx > >-----Original Message----- >From: techassist-bounce@xxxxxxxxxxxxx >[mailto:techassist-bounce@xxxxxxxxxxxxx]On Behalf Of LeRoy Westlund >Sent: Sunday, December 29, 2002 4:46 PM >To: techassist@xxxxxxxxxxxxx >Subject: [TechAssist] Re: Sony STR-DE405 > >David, >What is the problem with this unit ? >If your outputs seem to be OK, check for bad solder on R806. >should have +42.8 volts on both sides of R806. It provides the +24 volt >source for the speaker relay. > >LLW > >LeRoy Westlund >Westlund TV & Electronics " It's such a pretty world >93 North Main today !.... >Centerfield, UT 84622-0087 Look at the Sunshine. " >Ph./Fax 435-528-3822 :-) >mailto:LLW@xxxxxxxxxx > >-----Original Message----- >From: David Lessard <mrfixit@xxxxxxxxxxx> >To: techassist@xxxxxxxxxxxxx <techassist@xxxxxxxxxxxxx> >Date: Sunday, December 29, 2002 1:04 PM >Subject: [TechAssist] Re: Sony STR-DE405 >> >>Yeah, got his reply. I guess the measurement to ground on this pin is >>normal, sort of, still wondering why am I measuring 10 ohms to anaglog >>ground here if this pin is supposed to be connected to analog ground. >>Something to think about. Regardless, I'm going to fire the beast up, I'll >>let you know. >> >>-----Original Message----- >>From: techassist-bounce@xxxxxxxxxxxxx >>[mailto:techassist-bounce@xxxxxxxxxxxxx]On Behalf Of teltek2 >>Sent: Sunday, December 29, 2002 2:56 PM >>To: techassist@xxxxxxxxxxxxx >>Subject: [TechAssist] Re: Sony STR-DE405 >> >>David; >>Forgot a Panday...he's your Sony guru. Helped me out a couple of times. >> >>-Ed- >>Tel-Tek Electronics >>Ontario-Canada >> >>teltek2@xxxxxxxxxxxx >>----- Original Message ----- >>From: "D Panday" <dpanday@xxxxxxxxxxx> >>To: <techassist@xxxxxxxxxxxxx> >>Sent: Sunday, December 29, 2002 2:45 PM >>Subject: [TechAssist] Re: Sony STR-DE405 >>> >>> David, >>> >>> IC300 is the Surround Processor with Pin1 Vss (AGnd). >>> Panday >>> >>> >From: "David Lessard" <mrfixit@xxxxxxxxxxx> >>> >Reply-To: techassist@xxxxxxxxxxxxx >>> >To: <techassist@xxxxxxxxxxxxx> >>> >Subject: [TechAssist] Sony STR-DE405 >>> >Date: Sat, 28 Dec 2002 17:29:54 -0500 >>> > >>> >Techs, >>> > >>> >Does anyone know the function of IC300 (LV1011)? I'm reading 10 ohms >>> >between ground and pin #1, not sure if this is normal. Thanks again >>> >gang. Happy New Years. >>> > >>> >"Share what you know, Learn what you don't" >>> > >>> >David Lessard >>> >Alexandria Electronics >>> >50 Harrison Street >>> >Alexandria, Ontario >>> >K0C-1A0 >>> >mrfixit@xxxxxxxxxxx >>> > >>> >------------------------------------------ >>> >Submit A Repair Tip For Everyone Here: >>> >http://www.tech-assist.org/secure/tip/main.html >>> >------------------------------------------ >>> >To REMOVE your email address, click here: >>> > http://www.tech-assist.org/unsubb.html >>> >To CHANGE your email address, click here: >>> > http://www.techassist.net/forms/change.html > >------------------------------------------ >Submit A Repair Tip For Everyone Here: >http://www.tech-assist.org/secure/tip/main.html >------------------------------------------ >To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html >To CHANGE your email address, click here: > http://www.techassist.net/forms/change.html > > Peggs' Electronics 1519 West 2nd Street Owensboro,KY 42301 270-926-4968 fax 270-686-7399 ------------------------------------------ Submit A Repair Tip For Everyone Here: http://www.tech-assist.org/secure/tip/main.html ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html