Robert, All those I have seen do run hot. support@xxxxxxxxxxxxxxxxxx FAX 717-564-4952 Jeff Dougherty Intrepid Video & Electronics Be careful of your thoughts. 501 Luther Rd They may become your words Harrisburg, PA 17111 any moment. 717-909-8844 VCR tips, electronics info & general interest. www.intrepid-video.com www.tech-repair.net www.thetoolcaddy.com www.9-11-2001tragedy.com *********************************************************************** ----- Original Message ----- From: "tvservice" <tvservice@xxxxxxxxxxxxxxxxxxx> To: "Tech-Assist" <techassist@xxxxxxxxxxxxx> Sent: Thursday, January 09, 2003 10:27 AM Subject: [TechAssist] Sony KV32S45 P/S schematic Hey group, I have this set in for dead replace IC601 MX0841/872904112 and R607 .1ohm runs fine at +135.4 volts out but temperature sensor(index finger) says too hot after about 15 minutes. Is this normal to run hot? no caps in circuit that esr bad could use schematic of power supply if someone will send TIA Robert tvservice@xxxxxxxxxxxxxxxxxxx H & H Electronics Inc ------------------------------------------ Submit A Repair Tip For Everyone Here: http://www.tech-assist.org/secure/tip/main.html ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html ------------------------------------------ Submit A Repair Tip For Everyone Here: http://www.tech-assist.org/secure/tip/main.html ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html