Hey group, I have this set in for dead replace IC601 MX0841/872904112 and R607 .1ohm runs fine at +135.4 volts out but temperature sensor(index finger) says too hot after about 15 minutes. Is this normal to run hot? no caps in circuit that esr bad could use schematic of power supply if someone will send TIA Robert tvservice@xxxxxxxxxxxxxxxxxxx H & H Electronics Inc ------------------------------------------ Submit A Repair Tip For Everyone Here: http://www.tech-assist.org/secure/tip/main.html ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html