The first problem with this set was the burning of four-1 ohm resistors connected to one of the convergence STK's, IC 602. I replaced all the resistors and both STK's, using the higher current version, STK392-020. I took the convergence board back and installed it into the set, and the blue and green guns looked fine, but the red looked all haywire. The blue gun was blue and the green gun was green, but the red gun looked like it was not turned on except for the edges. Then when I put a crosshatch pattern into video 1, the blue and green were fine, but the red was all over the place. After 30 seconds the set shutoff and I discovered that IC602 was much hotter than IC601, and that fuses F601 and F602 were both now open. Help! I hope I won't have to bring the set in. TIA Kevin Wilks Kevin's TV & Video Repair Penticton BC Canada kevintv@xxxxxxx ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/