--------------------------------------------------------------- Text pasted from WinSTIPS 2.0 http://www.ServiceSoftware.com --------------------------------------------------------------- SONY KP53S15 Dead Palmetto Electronics, Inc. Ic1601 & Ic1602 (8-749-010-88) Stk392-010, And F1601 & F1602 (1-532-745-11) 3.15 Amp Fuse. All On D Board In Convergence Circuit. --------------------------------------------------------------- SONY KP53S15 Dead Set Tv Doctor - Thousand Oaks, Ca On Power Supply Pcb - Bad Standby Transformer - T603 & C667 470@ 25v Not Enough Voltage To 12 Volt Regulator --------------------------------------------------------------- SONY KP53S15 Dead,Relays Click On...Click Off Peggs Audio Output Ic Bad. Ic230 Tda7265 --------------------------------------------------------------- SONY KP53S15 Dead. Loud Noise, Smoke, Then Dead With Blinking Led Bryn Mawr Tv Ic230 Shorted On A Cba (Tda7265) Q601, Q602 Shorted (2sc4834) D651 (D4sbs4-F) Open R606 (0.1 Ohm 1/2w Fusible) C667 (470uf/25v) On G Cba --------------------------------------------------------------- SONY KP53S15 F1601 fuse intermittently blows. Supplies -15v on "D" board Rpz Electronics Replace Ic1601 and Ic1602 Stk392-010 modules --------------------------------------------------------------- SONY KP53S15 Intermitent Dead Dan Mundy, Cet/Csm Ic 1102 9v Regulator On U Board Slow To Come Up After Set Had Been On For Some Time Causing Power Down To Trip. This Ic Is Not On Schematic And Takes The Place Of The 9v Line Supplied To That Board. --------------------------------------------------------------- SONY KP53S15 No Vertical Deflection, May Cycle On And Off Dan Mundy, Cet/Csm Ic301 Cxa1477as 8 752 063 50 --------------------------------------------------------------- SONY KP53S15 Power Cycles On/Off Jnm Ic652 # 112694111 & C667 --------------------------------------------------------------- SONY KP53S15 Power Cycles With Front Led Replace Ic301 (Cxa1477as Or 8 752 063 50) --------------------------------------------------------------- SONY KP53S15 Power Cycles With Front Led CAUSE: Multiple; IC301 (CXA1477AS), STK392-010's, R1519 (2.2), and Vertical IC. REMARKS: Originally the set would try to turn on and would have R,G,B bowed lines at the very top of screen, pulsing with power cycling. IC301 had no vertical out pulse. Replaced Vert IC along with IC301 and then was blowing -15v fuse on Convergence "D" board. Replaced STK-392-010 IC's and set would still pulse on/off. Found R1519 @ 2.2ohm open causing no -15v to vertical IC Pin 4. --------------------------------------------------------------- SONY KP53S15 Power Won'T Completely Shut Off / 3 Lines On Top Of Screen And Led Still Stays Lit Tv Doctor - T.O., Ca Replace Both Relays On Power Supply Pcb - Will Cause Convergence Ic To Repeatly Fail --------------------------------------------------------------- SONY KP53S15 Shut Down At Turn On Or Blow Fuse In Convergence Output Replaced Ic005 8-759-370-31 (St24c01fb6) Sony Crossed To 8-759-280-75 (24c01cb1) Note Replaced This Eprom And Set Would Do Nothing / No Response, Put Old Ic Back In And Got Back To Original Problem. Called Sony Got Another Ic Same Problem. To Fix Set I Reinitialized The Ic And This Fixed The Set. --------------------------------------------------------------- SONY KP53S15 Shutdown Jnm Ic761 # 975916872 Cb Pcb --------------------------------------------------------------- SONY KP53S15 Shutdown, Clicks On Then Off. Garris Radio & Tv - New Bern, Nc. Replace Any Blown 3.15a Fuses On Convergence Board, Then Replaced Both Stk392-010 Convergence Ic'S, Then Check All Of The Parallel 4.7 Ohm Resistors Under Convergence Ic Heatsinks. Check Each Resistor By Lifting One Lead Off Pcb. Also Resolder These Resistors Because They Commonly Have Small Ring Cracks On Them. Check All For Solder. --------------------------------------------------------------- Bob Waterman, CET® #RI-28 Master Technician License #9109 Service Manager / Parts Manager Gemini Computer, TV, & Security Alarms (508)695-7302 (508)695-7769 FAX geminitv@xxxxxxxxxxx ----- Original Message ----- From: <bgrabowski@xxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Thursday, December 15, 2005 1:15 PM Subject: [TechAssist] Sony KP53S15 Anyone have a fix for a Sony KP53S15 that is in shutdown. HV comes up and then immediate shutdown. The B+ is right on at 135v and after taking 2nd anode lead off it will arc to ground almost 4 inches and burys the HV meter at over 40KV. Is there any common fault for this set. The 2 damper diodes test okay and the 2 critical caps are on the money any help would be appreciated. Thanks Bill G. Bill Grabowski Triangle Appliance Kenosha,WI 53142 ---------------------------------------------------------------------------- - This Email List is accessible to the general public through search engines. Remove: http://www.tech-assist.org/remove.htm Set Vacation mailto:ecartis@xxxxxxxxxxxxx?subject=set%20techassist%20vacation Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- This Email List is accessible to the general public through search engines. Remove: http://www.tech-assist.org/remove.htm Set Vacation mailto:ecartis@xxxxxxxxxxxxx?subject=set%20techassist%20vacation Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/