Poor connections on the bottom pcb. Try reseating the ribbon cables. You may also have to resolder some of the connectors. Also possible defective SMECs. Jerry Silverman Greentron Inc 4 Newland Ave Greenville SC 29609 864 232 3889 Fax 271 2080 mailto:greentron@xxxxxxx ----- Original Message ----- From: "preston McGiboney" <pmcgiboney@xxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Wednesday, October 02, 2002 10:12 AM Subject: [TechAssist] Sony CCD-FX620 > > This sony 8mm came in with tape in unit. Battery was > dead. Hooked to adaptor tape came out. Chassis closed > as normal. Now when power(any type) is applied you > get no mechanical movement and you get the error > signal. Also there is no drum rotation at all and no > mech noise at all from load motor. Any ideas? > > __________________________________________________ > Do you Yahoo!? > New DSL Internet Access from SBC & Yahoo! > http://sbc.yahoo.com > ------------------------------------------ > To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html > To CHANGE your email address, click here: > http://www.techassist.net/forms/change.html > ------------------------------------------ > ***NEW*** Tips Added Instantly!!!*** > Submit Repair Tips here: > http://www.tech-assist.org/secure/tip/ ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/