Is the static (center) convergence done via customer menu or by pots behind a small door on the bottom (side towards floor) near the front? If via customer menu, then you may be able to access convergence by entering the following on the remote: Press and hold "menu" for about 5 seconds, till display changes, then press 9 9 9 "Enter". If that works, it should come up in geometry adjust mode. I'm at home, so I'm doing this from memory, "CC", "prev chan" and "mute" (I think) select a color to converge, the number buttons select a type of adjustment (size, lin, pin skew, etc. some buttons will have a second function if pushed a second time) the arrow buttons change the settings, "enter" reverts the current adjustment to it's previous setting, "quit" brings up the convergence save menu (select yes to save and press enter or no to abandon changes). There are some variations on this. The newer projectors require a special set up remote, but this shouldn't be one of those. The older projectors have a convergence adjustment panel located under the bottom panel. HTH. Jerry Christians Electronic Service -----Original Message----- From: techassist-bounce@xxxxxxxxxxxxx [mailto:techassist-bounce@xxxxxxxxxxxxx]On Behalf Of DonsTVRepair@xxxxxxx Sent: Wednesday, February 20, 2002 12:16 PM To: techassist@xxxxxxxxxxxxx Subject: [TechAssist] Setting the convergence on a celiing mount projection tv Provision Elite 850.....manufactured by zenith.....ceiling mount projection unit.....projects up to 12'.....question is, how do you set the convergence?.....no menu functions or any obvious convergence board adjustments. ------------------- Don's TV Hut 1614 S. Combee Road Lakeland, FL 33801 863-668-9033 donstvrepair@xxxxxxx ------------------------------------------ Make your TechAssist database better! Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ ------------------------------------------ To UNSUBSCRIBE your email address, click here: mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe Or send a BLANK email with unsubscribe in the SUBJECT field to the address above. ------------------------------------------ Make your TechAssist database better! Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ ------------------------------------------ To UNSUBSCRIBE your email address, click here: mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe Or send a BLANK email with unsubscribe in the SUBJECT field to the address above.