Does this set have the setup switch on the crt pcb? if you bumped it or its bad the screen will go dark. learned from experience and several hours troubleshooting to find bad switch roy ----- Original Message ----- From: "Ron Miller" <rlmbkm@xxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Thursday, January 31, 2002 5:20 PM Subject: [TechAssist] Sanyo,DS25830,Inter.G2 voltage > > Unit goes dark when hot,can see very dark reddish blobs.Turned up G2 no > change,metered G2 pin was 185vdc left meter hooked up to pin removed crt pcb > (while set is running)reading jumped up to 600vdc is this the tube or the > fly? > Ron Miller > D.T.V. Texas > > > > ------------------------------------------ > Make your TechAssist database better! > Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ > ------------------------------------------ > To UNSUBSCRIBE your email address, click here: > mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe > Or send a BLANK email with unsubscribe in the > SUBJECT field to the address above. --- Outgoing mail is certified Virus Free. Checked by AVG anti-virus system (http://www.grisoft.com). Version: 6.0.320 / Virus Database: 179 - Release Date: 1/30/2002 _________________________________________________________ Do You Yahoo!? Get your free @yahoo.com address at http://mail.yahoo.com ------------------------------------------ Make your TechAssist database better! Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ ------------------------------------------ To UNSUBSCRIBE your email address, click here: mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe Or send a BLANK email with unsubscribe in the SUBJECT field to the address above.