Thanks..this one the relay clicks on...then off. -ED- teltek@xxxxxxxxxxxx > In a message dated 2/15/02 12:47:46 PM Pacific Standard Time, > teltek@xxxxxxxxxxx writes: > > >> Subj: [TechAssist] Sanyo 27" AVM-2747U Chassis-G5J-2747U1 >> Date: 2/15/02 12:47:46 PM Pacific Standard Time >> From: teltek@xxxxxxxxxxx (Tel-Tek Electronics) >> Sender: techassist-bounce@xxxxxxxxxxxxx >> Reply-to: <A >> HREF="mailto:techassist@xxxxxxxxxxxxx";>techassist@xxxxxxxxxxxxx</A> >> To: techassist@xxxxxxxxxxxxx (AAAA TECH-ASSIST) >> >> Ed i`m working on a similar model AVM 2753 set came in with only the relay >> clicking, check Q400 D1879 and was leaky. Also check for a lot of cold >> solder around that area and R008 and R009 220 ohms 10W wire wound resistor >> for cracks. I`m still working on the set but at least set goes on. Hope >> this help. >> >> >> Aviles Computer & Tv Repair >> Bronx, NY 10452 >> Fax # 1-718-681-3117 > > > > > > >> >> >> Would onyone have a partial on the Power Supply on the above set. Main and >> standby. >> I have one here that had a Power Surge, set wants to start, but relay clicks >> on and 4 seconds later clicks off. >> Then you can't turn it on again, unless you pull the plug. >> I don't believe HV ever comes up, but tries. >> >> -Ed- >> >> teltek@xxxxxxxxxxx >> > > > > > ------------------------------------------ > Make your TechAssist database better! > Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ > ------------------------------------------ > To UNSUBSCRIBE your email address, click here: > mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe > Or send a BLANK email with unsubscribe in the > SUBJECT field to the address above. > -=Ed=- -- From: Ed Gaidies teltek@xxxxxxxxxxx Tel-Tek Electronics ------------------------------------------ Make your TechAssist database better! Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ ------------------------------------------ To UNSUBSCRIBE your email address, click here: mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe Or send a BLANK email with unsubscribe in the SUBJECT field to the address above.