RU2M is correct for D559, D558 is R83F8. Jim Myers jr.myers@xxxxxxxxxxx ----- Original Message ----- From: "Shoreline Electronics" <jstielau@xxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Thursday, September 13, 2001 12:52 PM Subject: [TechAssist] Re: Sams 3481 section needed!!! > > Jim, > > Can you ID the correct diode part # for location D559 on this set? > > This one had a RU2M installed.... > > Jeff Stielau > Shoreline Electronics Repair > 125 Beechtree Lane > Westbrook,CT 06498 > 860-399-1861 > 860-664-3535 FAX > ----- Original Message ----- > From: "Jim Myers" <jr.myers@xxxxxxxxxxx> > To: <techassist@xxxxxxxxxxxxx> > Sent: Wednesday, September 12, 2001 5:35 PM > Subject: [TechAssist] Re: Sams 3481 section needed!!! > > > > > > Jeff, I have an original manual, pages too big for my fax machine but the > B+ > > for the Z board at pin 6 of its 8 pin connector is marked 27v and is the > > same source as the vertical ic. Some of the pincushion circuitry is on > this > > board and some is on the main board. > > Is this any help? > > Jim Myers > > jr.myers@xxxxxxxxxxx > > ----- Original Message ----- > > From: "Shoreline Electronics" <jstielau@xxxxxxxx> > > To: <techassist@xxxxxxxxxxxxx> > > Sent: Wednesday, September 12, 2001 2:36 PM > > Subject: [TechAssist] Sams 3481 section needed!!! > > > > > > > > > > Make : Panasonic > > > Model : CT27S18S > > > Problem : No pincushion adjust > > > > > > Can someone shoot me a quick fax of the pincushion schematic from Sams > > 3481. > > > > > > Supply volts to this circuit is only 5VDC...seems a little low! > > > > > > Jeff Stielau > > > Shoreline Electronics Repair > > > 125 Beechtree Lane > > > Westbrook,CT 06498 > > > 860-399-1861 Voice > > > 860-664-3535 Fax > > > jstielau@xxxxxxxx > > > > > > > > > Help make your TechAssist online repair tips > > > database better! Submit your fixes here: > > > http://www.circuitwork.com/techassist/tip/#tips > > > To unsubscribe write to: > > > techassist-request@xxxxxxxxxxxxx > > > with unsubscribe in the subject line. > > > > Help make your TechAssist online repair tips > > database better! Submit your fixes here: > > http://www.circuitwork.com/techassist/tip/#tips > > To unsubscribe write to: > > techassist-request@xxxxxxxxxxxxx > > with unsubscribe in the subject line. > > > > Help make your TechAssist online repair tips > database better! Submit your fixes here: > http://www.circuitwork.com/techassist/tip/#tips > To unsubscribe write to: > techassist-request@xxxxxxxxxxxxx > with unsubscribe in the subject line. Help make your TechAssist online repair tips database better! Submit your fixes here: http://www.circuitwork.com/techassist/tip/#tips To unsubscribe write to: techassist-request@xxxxxxxxxxxxx with unsubscribe in the subject line.