Hello all, I have been trying to tame this dog, but maybe someone else knows already. Set came in with wide pix and poor brightness. CR14701 is a known culpret. This was replaced and the width was touched up. two weeks later it comes back with Q14751 (chopper driver ) in the same power circuit with a shorted gate. (expensive part). The set fires up again. The width problem is back and Q14751 runs VERY hot. All else seems OK. Anyone have any experience with this? Jim McVey McVey Alltronix 327 Broadway Newburgh Ny 12550 ph: 845 561 8383 fx: 845 561 9017 Consumer electronics & computer service. Factory authorized for over twenty brands. ***************************************************************************** CHECK OUT THE NEW CHATROOM! Just login and click on chat! http://www.tech-assist.org/secure/tip/main.htm The Tech Address Book: http://www.tech-assist.org/secure/tip/contact.htm Add a Repair Tip Here, or Change/Remove your Email Address: http://www.tech-assist.org/secure/tip/main.htm Lost Password: http://www.tech-assist.org and select "Lost your Login Info?". Email Archives: //www.freelists.org/archives/techassist/