Neil, Change CR4118, RCA 164590. May check good, but break down under load. I change that diode on EVERY CTC169 that comes in just on principle. Ken Smith Gulf Technical Services 3034 Gulf Breeze Parkway Gulf Breeze, FL 32561 850-934-8324 (Voice) 850-932-0819 (Fax) ---------------------------- On Thu, 4 Oct 2001 20:23:30 EDT ELECTRONICACE@xxxxxxx writes: > > check cr4118,and the caps around the smps,especially the switch mode > reg ic. > > In a message dated 10/3/01 7:55:02 PM Eastern Daylight Time, > tvdoctors@xxxxxxxxxxxxx writes: > > > > > I brought module into shop for dead set symptoms. High Voltage > starts ups > > but goes right back off. Every once in a while set will turn on > with good > > picture and sound, but only to shut down again minutes later. I > replaced > High > > voltage divider block, but it didn't help. Any suggestions? > Regulator IC? > > Electrolytic? Vibration and cooling component's don't seem to have > any > effect. > > Neil, tvdoctors@xxxxxxxxxxxxx > > > > > Help make your TechAssist online repair tips > database better! Submit your fixes here: > http://www.circuitwork.com/techassist/tip/#tips > To unsubscribe write to: > techassist-request@xxxxxxxxxxxxx > with unsubscribe in the subject line. ________________________________________________________________ GET INTERNET ACCESS FROM JUNO! Juno offers FREE or PREMIUM Internet access for less! Join Juno today! For your FREE software, visit: http://dl.www.juno.com/get/web/. Help make your TechAssist online repair tips database better! Submit your fixes here: http://www.circuitwork.com/techassist/tip/#tips To unsubscribe write to: techassist-request@xxxxxxxxxxxxx with unsubscribe in the subject line.