Leonard, What about C4108(47m-50v) in the power supply? Is this one of the caps that you have already changed? Have had this cap cause problems like you discribed in the CTC169 direct view sets. Just a thought! Dan Webster Webster's TV Shullsburg, Wi. ----- Original Message ----- From: "Leonard Caillouet" <lcaillo@xxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Monday, June 20, 2005 12:51 PM Subject: [TechAssist] RCA P46730WK PTK169PCA slow to turn on > This one will power up and run fine, unless it is cold and the a.c. line > voltage is over 112 volts. Below that it works. Over that it is very slow > to start when the remote power is pressed, and sometimes will not start at > all. PS has been rebuilt with all of the typical components, the primary 4 > caps and chip, and CR4118 and its cap in the sec. The 5v standby reg > transistor and the 12 volt run transistor (this one was keeping the run > voltage low) were changed. There was goo from the rubber spacers melting in > the PIP module but this seemed to not affect anything. > > Any ideas on slow start issues? > > Leonard Caillouet > Electronics World > 1261 NW 76 Blvd > Gainesville, FL 32606 > 352-332-5608 > 352-332-5668 fax > > > -------------------------------------------------------------------------- --- > This Email List is Public. Remove: http://www.tech-assist.org/remove.htm > Set Vacation mailto:ecartis@xxxxxxxxxxxxx?subject=set%20techassist%20vacation > Lost Password: http://www.tech-assist.org and select "Login Problems?". > Email Archives: //www.freelists.org/archives/techassist/ > ----------------------------------------------------------------------------- This Email List is Public. Remove: http://www.tech-assist.org/remove.htm Set Vacation mailto:ecartis@xxxxxxxxxxxxx?subject=set%20techassist%20vacation Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/