[TechAssist] Re: RCA MODEL F27242GY CHASSIS CTC185AB
- From: "Robert Herring" <supertek66@xxxxxxxxxxx>
- To: <techassist@xxxxxxxxxxxxx>
- Date: Fri, 28 Sep 2001 17:28:35 -0500
Monte,
replace C3126 surface mount cap near micro
part # 217298 .22mfd 50v
Robert
supertek66@xxxxxxxxxxx
robert_herring@xxxxxxxx
H&H Electronics Inc
Dallas,Tx. 75233
----- Original Message -----
From: "DOCVIDEO" <DOCVIDEO@xxxxxxxxxx>
To: <techassist@xxxxxxxxxxxxx>
Sent: Thursday, September 27, 2001 12:16 PM
Subject: [TechAssist] RCA MODEL F27242GY CHASSIS CTC185AB
>
>
> Have this RCA 27" TV model # F27242GY Chassis CTC185AB, no schematic.
> Set came in with intermittent power up. If power button was pushed
several times
> would finally come on, would work fine. Cleaned all switches and
re-soldered. Under
> testing it would keep being intermittent.
> Checked whole board for bad solder and any cracks .
> Replaced the CH-UP and CH-DWN switches, which were intermittent.
Afterwards it
> powered up first time all functions were ok ... tried power off/on several
times each
> time it powered up......unplugged set let sit for an hour tried again
..all ok. Then
> let sit over night next morning it now has the relay clicking 3 times but
will not
> power up.
> Tried applying less voltage to powered-up with same results.
>
> Would like to have a copy of RCA's FixFinder sent if possible...and any
help
> possible.
> As most of know I do not repair TV's normally, but wanted to give this one
a try for
> a friend.
> Thanks for any assistance from the group.
>
>
>
>
> MONTE MONCRIEF
> BAKERSFIELD, CA.
> DOCVIDEO@xxxxxxxxxx
>
> Help make your TechAssist online repair tips
> database better! Submit your fixes here:
> http://www.circuitwork.com/techassist/tip/#tips
> To unsubscribe write to:
> techassist-request@xxxxxxxxxxxxx
> with unsubscribe in the subject line.
>
Help make your TechAssist online repair tips
database better! Submit your fixes here:
http://www.circuitwork.com/techassist/tip/#tips
To unsubscribe write to:
techassist-request@xxxxxxxxxxxxx
with unsubscribe in the subject line.
Other related posts:
