Thanks Wayne. Think I just found it. It was a bad ground. -Ed- Tel-Tek Electronics Ontario-Canada teltek3@xxxxxxxxxxxx teltek@xxxxxxxxx -----Original Message----- From: techassist-bounce@xxxxxxxxxxxxx [mailto:techassist-bounce@xxxxxxxxxxxxx] On Behalf Of Wayne Vanaman Sent: Wednesday, October 20, 2004 3:40 PM To: techassist@xxxxxxxxxxxxx Subject: [TechAssist] Re: RCA MM32110 Chassis MMC101GCE Check the "heavy" ground traces on the center of the chassis. The tend to break connections and cause weird problems. Wayne Vanaman Omega Electronics 6904 W Fairfield Dr Pensacola, Fl. 32506-3310 Wayne@xxxxxxxxxxxxxxxxxxxxx WWW.PensacolaTVRepair.Com 850-456-5995 voice 850-458-6369 fax Tel-Tek Electronics wrote: > I have a set here where I loose my Filament voltage to the CRT after a > few minutes. > > Anyone run into this previously. This chassis looks like it's a pig to > pull, and work on the underside. > > Any info regarding intermittent loss of filaments would be appreciated. > HV and sound stay when this happens. > > Thanks. > > -Ed- > > Tel-Tek Electronics > Ontario-Canada > > teltek3@xxxxxxxxxxxx > teltek@xxxxxxxxx > > > > > ------------------------------------------------------------------------ ----- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ > > ------------------------------------------------------------------------ ----- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/