A bad CR4501 will cause that problem. HTH. Paul Westcott Kingsway Electronics 1090 kingsway Sudbury,Ontario Canada Phone 705 566-9290 Fax 705 566-5349 ----- Original Message ----- From: "Jim Bailey" <baileystv@xxxxxxxxxxxx> To: "TechAssist" <techassist@xxxxxxxxxxxxx> Sent: Tuesday, February 10, 2004 10:07 AM Subject: [TechAssist] (RCA) F35670MBFM1 CTC187CN3 extreme fold over vertical! > This TV has a bright horizontal line through the middle of the picture with > extreme fold over from the middle to the top part of picture looks like > Venetian blinds and no picture from the middle down to the bottom. > I have replaced the vertical IC with no change in the picture; I have ESR > the capacitors in the vertical circuit and can't find any bad ones yet, > there is a 12volt line being dragged down to about 7 volts. > I am getting ready to check the pincushion board next but wondered if > anybody has seen this problem before. > Any help would be appreciated! > > Jim Bailey > Bailey's TV Sales & Service > Buckhannon, WV 26201 > baileystv@xxxxxxxxxxxx > > > > > -------------------------------------------------------------------------- --- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ > > ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/