The BASE of the HOT?!! Ground??? No F-ing way...... Go ahead, jumper it..... Maybe the tuner ground plane closest to the EEprom needs a jumper to the other side of the tuner shield...I've dealt with the Vert probs that way. Damon B Telrad Electronics Fort Wayne IN ----- Original Message ----- From: "Kevin's TV Repair" <kevintv@xxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Thursday, September 15, 2005 8:22 PM Subject: [TechAssist] RCA F27671SE, CTC177BF, dead, no ground to eeprom. > This set has a very unusual fault. I went to measure the voltage on > pins 5 and 6 of the eeprom and found that pin 6 has a varying voltage > from 2-5 volts. I then accidentally measured the voltage at pin 4 (which > is ground) and it measured the same. I then discovered that there was > no connection between the base of the HOT (which is ground) and the > tuner shield, eeprom ground. Does anyone know where the two sides > connect? I could just run a wire, but I would like to find the missing > link. Thanks. > > Kevin Wilks > Kevin's TV Repair > Penticton BC Canada > kevintv@xxxxxxx > > > > -------------------------------------------------------------------------- --- > This Email List is accessible to the general public through search engines. Remove: http://www.tech-assist.org/remove.htm > Set Vacation mailto:ecartis@xxxxxxxxxxxxx?subject=set%20techassist%20vacation > Lost Password: http://www.tech-assist.org and select "Login Problems?". > Email Archives: //www.freelists.org/archives/techassist/ > ----------------------------------------------------------------------------- This Email List is accessible to the general public through search engines. Remove: http://www.tech-assist.org/remove.htm Set Vacation mailto:ecartis@xxxxxxxxxxxxx?subject=set%20techassist%20vacation Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/