The solution was bad T-chip, guess it was causing the micro to hang up. Al G Al Gutz wrote: > > Have a 187 dead. HOT not shorted, smps OK, all 5V and 12V supplies good. > > On IC3001 (micro) pin 5 KD1 should be low 0V with positive pulse, this > is running at 2.5V no pulse. pin 6,7,8 KS1, KS2, KS3 are running at 2.5V > should be 4.7V. Unpluged keypad so no shorted switches. The wave form on > the crystal at pins 36,37b is good. No other waveforms on micro, supply > V is at 5V. Replaced eeprom. > Am I looking at a bad micro, want to be sure because it will likely cost > more than the set is worth but I have never ran into a bad micro on > these before. > Thanks for any help > > Al G > Al's TV-Electronics > Pembroke Ont. > Canada > > ***************************************************************************** > Classifieds! Buy or Sell! > http://sell.tech-assist.org > The Tech Address Book: > http://www.tech-assist.org/secure/tip/contact.htm > Add a Repair Tip Here, or Change/Remove your Email Address: > http://www.tech-assist.org/secure/tip/main.htm > Lost Password: > http://www.tech-assist.org and select "Lost your Login Info?". > Email Archives: > //www.freelists.org/archives/techassist/ ***************************************************************************** Classifieds! Buy or Sell! http://sell.tech-assist.org The Tech Address Book: http://www.tech-assist.org/secure/tip/contact.htm Add a Repair Tip Here, or Change/Remove your Email Address: http://www.tech-assist.org/secure/tip/main.htm Lost Password: http://www.tech-assist.org and select "Lost your Login Info?". Email Archives: //www.freelists.org/archives/techassist/