It looks like 15K 3 Watt but you need the service # to know for sure, What problems are you having?? I have one thats driving me nuts. I replaced the the convergence power supply no help and there is very low output on the power supply. 15v = 2.1v -15v= 1.4 v etc. Picture has very bad top and bottom pincushion. I can find no shorts on the convergence board, and I have clock and serial data and vert sync. I could use any comment you may have. Phillip R Hull STET phil245@xxxxxxxxxxxxx FAX 517--569-3075 Professional Technicians only ----- Original Message ----- From: "Robinson Electronics" <RobinsonElectronics@xxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Tuesday, April 27, 2004 12:52 PM Subject: [TechAssist] Proscan Proj. PTK195CP. Need value of resistor on conv. board (R19233), burnt. > Could someone tell me the value of R19233 on this conv. board, looks like a > 3 w mounted on stand-offs. > Can't read colors (overheated). > Thanks. David. > > Robinson Electronics > 1075 Sweeten Creek Road > Asheville, NC 28803 > Ph./Fax. 828 274-3787 > Toll Free. 866-899-3787 > www.robinsonelectronics.com > www.robelect.com > Mailto: RobinsonElectronics@xxxxxxxxxxx > > > > -------------------------------------------------------------------------- --- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ > > ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/