check cathode of cr4118 for at least 13vdc if too low replace you can use nte580 also check voltage at collector of hot should be 135-150vdc Tomlee wrote: > > Hello fellow tech. > I am working with ctc 169bg5. with the help with other techs Perry, JBC.I > force to turn on the tv by apply 5v at base of > Q4306. But the tv show a sign of on and off cycle. I do not hear the sound > of high voltage . I use the sencore to ring the > flyback by one end of probe to the B+ and the other end to colector of HOT > as sencore manual direction. But Get zero > ring .If I remove cr402 and L803 I will get maximum 30 rings.(The HOT > colector connect to ground by 2 diode CR 401 and cr402 ). I means If The > HOT collector connect to ground or connect to pincustion circuit(through > L803) It will make zero ring on flyback test.Does this means somthing wrong > at pincushion ckt or B+ to ground ckt . I measure no short to B+. . > May be it is only short to horizontal frequency?.Any Ideas from experince > tech is appriciated.I spend too much time for this . > Dang TVCR > > ------------------------------------------ > Make your TechAssist database better! > Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ > ------------------------------------------ > To UNSUBSCRIBE your email address, click here: > mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe > Or send a BLANK email with unsubscribe in the > SUBJECT field to the address above. ------------------------------------------ Make your TechAssist database better! Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ ------------------------------------------ To UNSUBSCRIBE your email address, click here: mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe Or send a BLANK email with unsubscribe in the SUBJECT field to the address above.