Hello Phil. Yes I do have 15v at cr4418. I will check C4402. c4401 and c4402 connect together from HOT (collector) to ground. Thanks ----- Original Message ----- From: "Phillip R. Hull" <phil245@xxxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Monday, January 28, 2002 11:31 AM Subject: [TechAssist] Re: Proscan CTC 169bg5 shut down > > Did you change CR4118 yet?(Do you have 15v) If so change C4402, if this > cap goes just a little low in value I have seen the set shut down > Phillip R Hull > phil245@xxxxxxxxxxxxx > ----- Original Message ----- > From: "Tomlee" <t8872695@xxxxxxxxxxxxx> > To: <techassist@xxxxxxxxxxxxx> > Sent: Monday, January 28, 2002 1:31 PM > Subject: [TechAssist] Proscan CTC 169bg5 shut down > > > > > > Hello fellow tech. > > I am working with ctc 169bg5. with the help with other techs Perry, JBC.I > > force to turn on the tv by apply 5v at base of > > Q4306. But the tv show a sign of on and off cycle. I do not hear the > sound > > of high voltage . I use the sencore to ring the > > flyback by one end of probe to the B+ and the other end to colector of HOT > > as sencore manual direction. But Get zero > > ring .If I remove cr402 and L803 I will get maximum 30 rings.(The HOT > > colector connect to ground by 2 diode CR 401 and cr402 ). I means If The > > HOT collector connect to ground or connect to pincustion circuit(through > > L803) It will make zero ring on flyback test.Does this means somthing > wrong > > at pincushion ckt or B+ to ground ckt . I measure no short to B+. . > > May be it is only short to horizontal frequency?.Any Ideas from experince > > tech is appriciated.I spend too much time for this . > > Dang TVCR > > > > ------------------------------------------ > > Make your TechAssist database better! > > Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ > > ------------------------------------------ > > To UNSUBSCRIBE your email address, click here: > > mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe > > Or send a BLANK email with unsubscribe in the > > SUBJECT field to the address above. > > > > > > ------------------------------------------ > Make your TechAssist database better! > Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ > ------------------------------------------ > To UNSUBSCRIBE your email address, click here: > mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe > Or send a BLANK email with unsubscribe in the > SUBJECT field to the address above. > ------------------------------------------ Make your TechAssist database better! Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ ------------------------------------------ To UNSUBSCRIBE your email address, click here: mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe Or send a BLANK email with unsubscribe in the SUBJECT field to the address above.