I'll send you the original program, privately. See if it works better for you. -Ed- Tel-Tek Electronics Ontario-Canada teltek3@xxxxxxxxxxxx ----- Original Message ----- From: "Randall Torda" <lectrics284@xxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Monday, March 22, 2004 4:30 PM Subject: [TechAssist] Pony Program > Hi, > > I've been using an I2C serial programmer to copy eproms on these new > TV's. I've tried the PonyProg2000 software with the parallel I2C > interface (http://www.lancos.com) since the ciruit was easy to > breadboard. > Setup and calibration with PonyProg2000 sets up OK, but when I > want to read or write...won't work. I doubled checked and triple checked > breadboard circuit. I'm using Windows 2000. Should I use the serial > interface and breadboard that circuit? Is the parallel I2C schematic > wrong? > Appreciate any input.. > > Autolectrics > Randall Torda > 284 Makua Street > Wailuku, HI 96793 > Fax 808-244-3064 > > > > -------------------------------------------------------------------------- --- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ > ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/