Has anyone had any experience with intermittant shutdown after installing a new Large Signal Board? This is a field service call which was originally dead, no HV/sweep, no indication of power at the power led. After installation the new board operated fine, on a second call the B+ was adjusted to 128V from 130.2 Volts, the Tv ran fine with each visit; the customer stated that if she turns off TV and comes back after 30 minutes she cannot get it to turn on. I ran it 30 mins, turned it off, and it still comes on without a hitch. Not sure why this is happening. Hopefully somebody has some info about this unit not turning on after being turned off for some time. TIA Damon Brunger damon101@xxxxxxxxxxxxxx Telrad Electronic Services Ft Wayne, IN 46815 ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/