This micro runs on 3.3 volt check the power supply for two 1 ohm 1/2 watt resistors in parallel R808 and R809 (I believe) you will need to unsolder to check, these are current limiters and you may find one is open or bad solder Robert tvservice@xxxxxxxxxxxxx H & H Electronics Inc Dallas, TX ----- Original Message ----- From: "ben daniels" <benstv74820@xxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Monday, November 24, 2003 3:29 PM Subject: [TechAssist] Panasonice CT35G25B Shut down no remote no menu > This mod: CT_35G25B will shutdown when you change > channel to no signal. Set may play hours if you don't > change channels. There is no menu or remote won't > work. Have changed IC-001 (mirco) pin has no 5 volts. > Voltages I think come out of ic??? but there is zero. > When the set shuts down you have to unplug to reset. > Just letting it set won't work. Any ideas? Thanks Ben > > ===== > Randy Daniels > Ben's TV Repair > 1703 No. Brdwy. > Ada, Okla. 74820 > > __________________________________ > Do you Yahoo!? > Free Pop-Up Blocker - Get it now > http://companion.yahoo.com/ > **************************************************************************** * > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ > ***************************************************************************** Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/