well I thought it was the vertical IC and it is butt vcc on pin 12 is 30v and pin 7vcc is 30V pin 11 vertical output is 0 pin 8 is 0 blew vertical chip after 5 minutes any help Please this is a dogg. Eric G. ----- Original Message ----- From: "Shoreline Electronics" <jstielau@xxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Tuesday, February 05, 2002 7:13 PM Subject: [TechAssist] Re: Panasonic PV M2044 No raster > > Well.....if your still getting G2 I assume you still hot H-drive & HV on the > 2nd anode? > > If your losing filaments trace back to the source.....usually flyback! > > Jeff Stielau > Shoreline Electronics Repair > 125 Beech Tree Lane > Westbrook, CT 06498 > 860-399-1861 > 860-664-3535 (fax) > ----- Original Message ----- > From: "Eric gundersen" <redwitch01@xxxxxxxx> > To: <techassist@xxxxxxxxxxxxx> > Sent: Tuesday, February 05, 2002 8:10 PM > Subject: [TechAssist] Panasonic PV M2044 No raster > > > > set come on and then operated for 15 minuts then no raster has sound G2 at > 182V b+ at 130V no heater need help do not have print for this unit all > replies welcome. Eric G. > > > > ------------------------------------------ > > Make your TechAssist database better! > > Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ > > ------------------------------------------ > > To UNSUBSCRIBE your email address, click here: > > mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe > > Or send a BLANK email with unsubscribe in the > > SUBJECT field to the address above. > > > > > > > ------------------------------------------ > Make your TechAssist database better! > Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ > ------------------------------------------ > To UNSUBSCRIBE your email address, click here: > mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe > Or send a BLANK email with unsubscribe in the > SUBJECT field to the address above. > > ------------------------------------------ Make your TechAssist database better! Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ ------------------------------------------ To UNSUBSCRIBE your email address, click here: mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe Or send a BLANK email with unsubscribe in the SUBJECT field to the address above.