Got It Fixed!! Replaced shorted HOT Q551 (D2539) and replaced C820 (15 mfd @ 63 volts) in P/S, also replaced C756 and C757 in pincushion replaced both with (220 mfd @ 50 volt) some spot cold solder joints and it looks good. Shaun Advanced Electronics 224 West Riverview Ave. Fort Morgan, CO 80701 ----- Original Message ----- From: "Shaun" <satguy@xxxxxxxxxxxxx> To: "tech" <techassist@xxxxxxxxxxxxx> Sent: Saturday, September 03, 2005 5:02 PM Subject: [TechAssist] Panasonic CT-36G33W Chassis ALEDP313 in SHUT DOWN > This set will try to turn on then go into shut down. I replaced the shorted > Horz output that was bad. I also replaced the flyback and no help. The high > voltage comes up then it shuts off and AC must be removed to get it to try > again. Any notes on this set out there? > > Shaun > > Advanced Electronics > 224 West Riverview Ave. > Fort Morgan, CO 80701 > > -------------------------------------------------------------------------- --- > This Email List is accessible to the general public through search engines. Remove: http://www.tech-assist.org/remove.htm > Set Vacation mailto:ecartis@xxxxxxxxxxxxx?subject=set%20techassist%20vacation > Lost Password: http://www.tech-assist.org and select "Login Problems?". > Email Archives: //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- This Email List is accessible to the general public through search engines. Remove: http://www.tech-assist.org/remove.htm Set Vacation mailto:ecartis@xxxxxxxxxxxxx?subject=set%20techassist%20vacation Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/