I had one awhile back doing that. It was a bad solder connection in the HV area. Jorge Camboni wrote: > The chassis is a CTC169PCA , it's stretching and shrinking horizontally > all the time. just a few inches, green seems to make the widest excursion. > there's some vertical instability as well, not so pronounced. Tried > disconnecting convergence control board an it's just the same > Power supply and horiz. output are checked ok. Suppose something wrong > around jungle ic, but couldn't go much further at the customer's house. > gotta get back with better ideas.....:)) Hope someone can help a little > about it. > Thanks Jorge Camboni GY Electronics, Dallas > > _________________________________________________________ > Do You Yahoo!? > Get your free @yahoo.com address at http://mail.yahoo.com > > ------------------------------------------ > Make your TechAssist database better! > Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ > ------------------------------------------ > To UNSUBSCRIBE your email address, click here: > mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe > Or send a BLANK email with unsubscribe in the > SUBJECT field to the address above. -- Doug Keller Wis-Kel Electronics 101 Freeland Ave. Terra Alta, WV USA 26764 1-304-789-5889 ------------------------------------------ Make your TechAssist database better! Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ ------------------------------------------ To UNSUBSCRIBE your email address, click here: mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe Or send a BLANK email with unsubscribe in the SUBJECT field to the address above.