what ever happened to the ,cut the wire and splice using the double shrink tubing methode? Damon wrote: > Yes, I have seen the HV Splitter fail on this, and all you can do is pull on > the wire until it pops free, I usually grab right at the splitter and > leverage it against the splitter's body. Generally, if you don't wrench the > wire back and forth it seems to not damage the wire or the clamper. Good > luck on this. > > Damon Brunger > damon101@xxxxxxxxxxxxxx > Telrad Electronic Services > Ft Wayne, IN 46815 > ----- Original Message ----- > From: "Ron Miller" <rlmbkm@xxxxxxxx> > To: <techassist@xxxxxxxxxxxxx> > Sent: Monday, November 26, 2001 12:04 PM > Subject: [TechAssist] PTK 195LV,horiz out shorted > > > > > CTC195195E,lightbox.The flyback rings good drawing # 15128-12D,has new > type > > dist block in it.tried to remove HV lead going between flyback and block ( > > both ends ) is this a twist and pull type connector?Want to un load > flyback > > and look at collector waveform,is fly or block a high failure item in this > > set, like bad dist blocks in ctc169s.Thanks > > Ron Miller > > D.T.V. Texas > > > > > > ================================= > > Help make your TechAssist database better! > > Submit your fixes here: http://circuitwork.com/techassist/tip/#tips > > ================================= > > To UNSUBSCRIBE your email address, click here: > > mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe > > > > > > ================================= > Help make your TechAssist database better! > Submit your fixes here: http://circuitwork.com/techassist/tip/#tips > ================================= > To UNSUBSCRIBE your email address, click here: > mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe ================================= Help make your TechAssist database better! Submit your fixes here: http://circuitwork.com/techassist/tip/#tips ================================= To UNSUBSCRIBE your email address, click here: mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe