Hey Jonas, I have seen this before, Check for bad shield ground connections and connections around the three regs on the the signal board. this takes care of most problems on the 170, also check the power supply caps around the reg drive ic on sweep bd. Tony Saracco TCS ELECTRONICS 406 Andra Ct. Gilberts, IL 60136 tcselectronics@xxxxxxxxx ----- Original Message ----- From: "jonas miglinas" <miglinasj@xxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Tuesday, March 02, 2004 10:31 PM Subject: [TechAssist] PS 35682 CTC170 Hello all, Found this Proscan set dead and after throwing out a few capacitors in the power supply the set fired up. Sound is ok but the picture has the sides closed in about 4 inches. High voltage measures only 18 KV, should be about 30 KV. Checked the capacitors in the horizontal circuit and all are on the money. B+ is ~ 138v. Lent my schematic to another shop and now I'm at a bit of a loss at what to check next. If anyone has seen this problem before or if you have a suggestion as to what to check next I would appreciate it. Jonas Miglinas Miglinas TV Chicago ---------------------------------------------------------------------------- - Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/