We're using Orion service manual. TV came in dead. HOT was shorted, C446 (1@160v) in horizontal driver circuit was open, and R506 (180 ohm @ 20w) in regulator was open. Then no vertical deflection. Changed vertical out ic401 (LA78041). Then had picture but no B+ regulation. STR30110 was shorted and R515 (1.5@3w) was open. Changed those parts, but raster is pulled in on sides, with B+ of only 110v. Schematic shows output of regulator is supposed to be 135v (even though it's an STR30110). Pin 5 of STR is 0, but should be 6.9v. We used the light bulb technique to eliminate the horizontal section and regulated voltage didn't improve. Checked all resistors and caps in regulator and tried another STR. Unfortunately, both STR's were purchased from same place and have same #'s. Bad batch of STR's? Any suggestions appreciated. Jeff Smith Smith TV Service 1930 Main St Newberry, SC 29108 803/276-4946 ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.tech-assist.org/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/