Techs, I have a Mits projo that has a shutdow problem. Here are the checks I've made without schematics: 1) I have about 125VDC at collector at turn. 2) I have burst of about 30KV at flyback output 3) I have all the voltages at turn before shutdown +24,+18,-24,+8, etc. 4) There was a slight leak on the vertical IC area that was cleaned up and the vertical IC was replaced. There was no leak at the signal board. 5) I've ESR'd alot of the lytics and found non bad. 6) I've replaced both convergence IC's 7) I've soldered all yoke pin connections One thing that was observed when first plugged in...the power LED blinked three times. Any help would be appreciated. I would appreaciate a print of power supply, drive circuits, and trouble codes, or any thing that would correspond to the three blinks. Thanks. Autolectrics Randall Torda 284 Makua Street Wailuku, HI 96793 ----------------------------------------------------------------------------- This Email List is Public. Remove: http://www.tech-assist.org/remove.htm Lost Password: http://www.tech-assist.org and select "Login Problems?". Appliance Repair List: http://www.tech-assist.org/secure/tip/chatjoin.htm#app Email Archives: //www.freelists.org/archives/techassist/