Paul, From Mitsubishi: HORIZONTAL COLLAPSE Cause #1 1. REPLACE HORIZONTAL DRIVE TRANSFORMER T501 AND RESISTOR R505. ORDER KIT PART #CM-KIT UNSTABLE HORIZONTAL RASTER Cause #1 1. CHECK C5001 .33 UFD @ 35V TANT. OFF PIN 1 OF IC5000 IN THE HV REGULATOR CIRCUIT ON THE MAIN PCB. PCC WONT ADJUST Cause #1 1. CHECK FOR 35V AT COLLECTOR OF Q5A1. IF HIGH REPLACE D503 IN PCC CIRCUIT. PCB-DEFL PART #264P157010 2. CHECK FOR SHORTED Q5A1 IN PCC CIRCUIT. PCB-DEFL PART #260P420020 3. CHECK IC501 PIN 2 FOR VERTICAL WAVEFORM AND PIN 3 FOR HORIZONTAL WAVEFORM. IF NO OUTPUT AT PIN 8 REPLACE IC501. PCB-DEFL PART #272P132010 Jeff Dougherty Intrepid Video TV/VCR 263 S Front St Steelton PA 17113 fax...717-564-4952 www.intrepid-video.com www.tech-repair.net ----- Original Message ----- From: "Paul" <dntwntv@xxxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Friday, March 19, 2004 7:50 PM Subject: [TechAssist] Mitsubishi VS 6015 R in on sides This set has raster in on the sides about an inch and can not adjust out with width control. B+ 130v. Have 12 volts to side pcc I/C 501. Any notes for a fix of this problem? Paul Paul ,B Central TV&Video Grover Beach Ca. ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/