Is relay energized ? Adolph Gower Cordova TV 10275 Old Placerville Rd. #5 Sacramento, Ca. 95827-3044 Phone (916) 363-6565 Fax (916)363-7623 Email:dolph1133@xxxxxxxxxxx -----Original Message----- From: techassist-bounce@xxxxxxxxxxxxx [mailto:techassist-bounce@xxxxxxxxxxxxx]On Behalf Of D Thunhurst Sent: Monday, January 06, 2003 6:29 AM To: techassist@xxxxxxxxxxxxx Subject: [TechAssist] Re: Magnavox RK5554, 27P1 ch....can't turn off Yes I did change this zener. I had 5.2v on the old one and now I have 5.6v on the new one. Still no help. Daryl Daryl's TV 3310 Dyer St. El Paso, TX 79930 915-565-9184 915-564-1024 Fax http://dynacomp.freeyellow.com -----Original Message----- From: Gemini Computer & TV <geminitv@xxxxxxxxxxxxxxxx> To: techassist@xxxxxxxxxxxxx <techassist@xxxxxxxxxxxxx> Date: Monday, January 06, 2003 6:14 AM Subject: [TechAssist] Re: Magnavox RK5554, 27P1 ch....can't turn off > >Did you replace Z430? The original part number of 5303000001 is in the old >10NC Philips part number format while the "new" part number 483513097005 is >the 12NC part number system. > >Bob Waterman, CET® #RI-28 >Master Technician License #9109 >Service Manager >Gemini Computer, TV, & Security Alarms >(508)695-7302 >(508)695-7769 FAX >geminitv@xxxxxxxxxxxxxxxx >geminitv@xxxxxxx > >----- Original Message ----- >From: "D Thunhurst" <dthunhurst@xxxxxxx> >To: <techassist@xxxxxxxxxxxxx> >Sent: Friday, January 03, 2003 7:00 PM >Subject: [TechAssist] Re: Magnavox RK5554, 27P1 ch....can't turn off > > >> >> Bob, >> Thanks so much for your reply. >> With a bit of embarrassment, I was interrupted several times while trying >to >> post this problem that I failed mention I already replaced IC400 and >IC402. >> I also replaced C459 and C431. I also resoldered the usual poor solder >> joints that these sets all have. I checked as suggested, C421, C430, R427 >> and R428. My voltages on Q433 are: >> C=9.2 >> B=0 >> E=0 >> this is with the set in the "on" mode. >> C=8.4 >> B=.6 >> E=0 >> this is in the "off" mode. >> There is 9.4v on P2 of IC402 with no change in voltage in "on" or "off" >> mode. I would definitely say that IC402 is the culprit but I did already >> change it to no avail. You mentioned that the 483513097005 replaces >> 5303000001. Is this possibly an upgrade for this problem as I had the old >> number in stock. >> This seems to be the only problem with this set. Everything else is >working >> properly. >> Again, thanks for your help. >> Daryl >> Daryl's TV >> 3310 Dyer St. >> El Paso, TX 79930 >> 915-565-9184 >> 915-564-1024 Fax >> http://dynacomp.freeyellow.com >> -----Original Message----- >> From: Gemini Computer & TV <geminitv@xxxxxxxxxxxxxxxx> >> To: techassist@xxxxxxxxxxxxx <techassist@xxxxxxxxxxxxx> >> Date: Thursday, January 02, 2003 6:37 PM >> Subject: [TechAssist] Re: Magnavox RK5554, 27P1 ch....can't turn off >> >> >> > >> >First thing to do is replace IC402 (optoisolator IC). It is part # >> >483513097005 (formerly part# 5303000001). If that does not take care of >it, >> >then check Z430, C421, C430, R427, R428, Q433, and IC400. I am almost >> >certain this should cure it. let us know how you make out. >> > >> >Bob Waterman, CET® #RI-28 >> >Master Technician License #9109 >> >Service Manager >> >Gemini Computer, TV, & Security Alarms >> >(508)695-7302 >> >(508)695-7769 FAX >> >geminitv@xxxxxxxxxxxxxxxx >> >geminitv@xxxxxxx >> > >> >----- Original Message ----- >> >From: "D Thunhurst" <dthunhurst@xxxxxxx> >> >To: <techassist@xxxxxxxxxxxxx> >> >Sent: Thursday, January 02, 2003 7:50 PM >> >Subject: [TechAssist] Re: Magnavox RK5554, 27P1 ch....can't turn off >> > >> > >> >> >> >> Thanks for the reply. >> >> Is this the famous 100@200v cap you have reference to? If so, this set >> >> doesn't use it. C432 on this set is a .1@50v cap. >> >> Daryl >> >> Daryl's TV >> >> 3310 Dyer St. >> >> El Paso, TX 79930 >> >> 915-565-9184 >> >> 915-564-1024 Fax >> >> http://dynacomp.freeyellow.com >> >> -----Original Message----- >> >> From: TV Doctors <tvdoctors@xxxxxxxxxxxxx> >> >> To: techassist@xxxxxxxxxxxxx <techassist@xxxxxxxxxxxxx> >> >> Date: Thursday, January 02, 2003 4:55 PM >> >> Subject: [TechAssist] Re: Magnavox RK5554, 27P1 ch....can't turn off >> >> >> >> >> >> > >> >> > >> >> >Change C432 >> >> >-------Original Message------- >> >> > >> >> >From: techassist@xxxxxxxxxxxxx >> >> >Date: Thursday, January 02, 2003 01:59:09 PM >> >> >To: TechAssist >> >> >Subject: [TechAssist] Magnavox RK5554, 27P1 ch....can't turn off >> >> > >> >> >Hi, >> >> >This Magnavox is eating my lunch. The set comes on at plug in. The >relay >> >> >is used solely for degauss. The on-off circuit is controlled by the >> micro >> >> >and is giving me "0" volts in the "on" position and ".6" volt at turn >> >off. >> >> >I have replaced Q430, Q431, Q432, Q433, Z430, R437, C435, and C436. >> >> >The schematic shows that the base of Q432 is connected to the micro >and >> I >> >> am >> >> >getting the biasing on that transistor (marked as on-off switch). >> >> >This set is very sensitive to temperature. When components are heated, >> >the >> >> >set can be turned off. >> >> >A simple solution you say?? I thought so too!! >> >> >Every component I stated I replaced was because when I would place the >> >tip >> >> >of the soldering iron just close to each of the various components, >the >> >set >> >> >would function properly. Freeze the parts and the set could not be >> turned >> >> >off. >> >> >I even mounted the parts in question on the bottom of the board as not >> to >> >> >heat or cool any other part and thought to have confirmed the culprit. >> >> >After replacing the part or parts in question using OEM parts, the >same >> >> >symptom occurred, even with the new parts, absolutely no change. >> >> >I am now at a loss as I have replaced or subbed every part that was >> >> effected >> >> >by heating and cooling. Now I know how a new born calf looking at a >gate >> >> >must feel. >> >> >Any ideas or advice would be appreciated. >> >> >Thanks >> >> >Daryl >> >> >Daryl's TV >> >> >3310 Dyer St. >> >> >El Paso, TX 79930 >> >> >915-565-9184 >> >> >915-564-1024 Fax >> >> >http://dynacomp.freeyellow.com >> >> > >> >> >------------------------------------------ >> >> >Submit A Repair Tip For Everyone Here: >> >> >http://www.tech-assist.org/secure/tip/main.html >> >> >------------------------------------------ >> >> >To REMOVE your email address, click here: >> >> >http://www.tech-assist.org/unsubb.html >> >> >To CHANGE your email address, click here: >> >> >http://www.techassist.net/forms/change.html >> >> > >> >> > >> >> >------------------------------------------ >> >> >Submit A Repair Tip For Everyone Here: >> >> >http://www.tech-assist.org/secure/tip/main.html >> >> >------------------------------------------ >> >> >To REMOVE your email address, click here: >> >> > http://www.tech-assist.org/unsubb.html >> >> >To CHANGE your email address, click here: >> >> > http://www.techassist.net/forms/change.html >> >> > >> >> > >> >> >> >> ------------------------------------------ >> >> Submit A Repair Tip For Everyone Here: >> >> http://www.tech-assist.org/secure/tip/main.html >> >> ------------------------------------------ >> >> To REMOVE your email address, click here: >> >> http://www.tech-assist.org/unsubb.html >> >> To CHANGE your email address, click here: >> >> http://www.techassist.net/forms/change.html >> >> >> >> >> > >> >------------------------------------------ >> >Submit A Repair Tip For Everyone Here: >> >http://www.tech-assist.org/secure/tip/main.html >> >------------------------------------------ >> >To REMOVE your email address, click here: >> > http://www.tech-assist.org/unsubb.html >> >To CHANGE your email address, click here: >> > http://www.techassist.net/forms/change.html >> > >> > >> >> ------------------------------------------ >> Submit A Repair Tip For Everyone Here: >> http://www.tech-assist.org/secure/tip/main.html >> ------------------------------------------ >> To REMOVE your email address, click here: >> http://www.tech-assist.org/unsubb.html >> To CHANGE your email address, click here: >> http://www.techassist.net/forms/change.html >> >> > >------------------------------------------ >Submit A Repair Tip For Everyone Here: >http://www.tech-assist.org/secure/tip/main.html >------------------------------------------ >To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html >To CHANGE your email address, click here: > http://www.techassist.net/forms/change.html > > ------------------------------------------ Submit A Repair Tip For Everyone Here: http://www.tech-assist.org/secure/tip/main.html ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html ------------------------------------------ Submit A Repair Tip For Everyone Here: http://www.tech-assist.org/secure/tip/main.html ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html