Hi, I have this Magnavox with a 25S102 chassis that came in dead. I checked the semi's and esr'd the electro's. I had 167 volts raw B+ and only 16 volts out of the regulator. In checking the resistors, I found R407, open (100 ohm). I replaced it and didn't find anything else bad. I plugged the set in and turned it on and bang, boom and smoke. The resistor I just replaced, R407, along with Q400, Q402, Q403, Q410, R408, and F401 all went bye bye. Previously all but R407 were good. R408 and Q410 are burned beyond recognition and I have no idea of their values. Resistances of IC430 (STR30130) checks the same as a new one and the HOT is not shorted. Has anyone encountered this before and have an idea where to go from here? I do not have a schematic on this one. Thanks for you help, Daryl Daryl's TV 3310 Dyer St. El Paso, TX 79930 915-565-9184 915-564-1024 Fax http://dynacomp.freeyellow.com ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/