[TechAssist] Re: KV27TS30 Blows Horz. output transistor

  • From: "Gemini Computer & TV" <geminitv@xxxxxxxxxxxxxxxx>
  • To: <techassist@xxxxxxxxxxxxx>
  • Date: Tue, 16 Sep 2003 16:20:29 -0400

Besides what is below, replace C525 (0.47mfd/50V). Make sure you resolder
the horizontal driver transformer. Also replace the VDRs in the power
supply.
---------------------------------------------------------------
Text pasted from WinSTIPS 2.0
http://www.ServiceSoftware.com
---------------------------------------------------------------

SONY   KV27TS32

Repeat failure of R607, Q601, Q602 & Q591

Roger Carnell

Solder connections bad on Horiz drive xformer

---------------------------------------------------------------

SONY   KV27TS32

Dead

Frank @ HQ Electronics & Satellite

Found Solder Had Cracked And Eroded Away From Emitter Pin Of Hot, Q503 /
2sc4927. Also Found Base Connection Solder Bad. Hot Xistor Was Shorted. It
Also Took Out The Following Power Supply Components:
Q601 And Q602 / 2sc4834,
Vdr601  1-807-288-11
Vdr'S 602 And 603  1-810-053-11,
R607 .1 Ohm 1/2 Watt Fusible Resistor.

Repaired 20-25 Other Bad Solder Connections On The Circuit Board In Various
Circuits, Including Driver Transformer. (Capacitor In Driver Ckt. Primary
Had Been Replaced A Short Time Before By Another Shop.)

---------------------------------------------------------------

Bob Waterman, CET® #RI-28
Master Technician License #9109
Service Manager / Parts Manager
Gemini Computer, TV, & Security Alarms
(508)695-7302
(508)695-7769 FAX
geminitv@xxxxxxxxxxxxxxxx
geminitv@xxxxxxx
www.geminicomputertvsecurityalarms.com

----- Original Message ----- 
From: "Neil Bowman" <tvdoctors@xxxxxxxxxxxxx>
To: <techassist@xxxxxxxxxxxxx>
Sent: Tuesday, September 16, 2003 1:07 PM
Subject: [TechAssist] KV27TS30 Blows Horz. output transistor


> Sometimes it also blows the regulator and the  large resistors next to the
regulator.  Changened the flyback and the yoke.  Any tips on this unit fom
intermittant blowing of the hot.  Previous repairs done but brought back 2
days later. this was done 2 other times. now this time can't get running.
Keeps blowing hot.  Any suggestions   Thanks,  Neil
> TV Doctors
> Monroe,Wa.
>
****************************************************************************
*
> Classifieds! Buy or Sell!
> http://sell.tech-assist.org
> The Tech Address Book:
> http://www.tech-assist.org/secure/tip/contact.htm
> Add a Repair Tip Here, or Change/Remove your Email Address:
> http://www.tech-assist.org/secure/tip/main.htm
> Lost Password:
> http://www.tech-assist.org  and select "Lost your Login Info?".
> Email Archives:
> //www.freelists.org/archives/techassist/
>

*****************************************************************************
Classifieds! Buy or Sell!
http://sell.tech-assist.org
The Tech Address Book:
http://www.tech-assist.org/secure/tip/contact.htm
Add a Repair Tip Here, or Change/Remove your Email Address:
http://www.tech-assist.org/secure/tip/main.htm
Lost Password:
http://www.tech-assist.org  and select "Lost your Login Info?".
Email Archives:
//www.freelists.org/archives/techassist/

Other related posts: