Problem is due to excess beam current at CRT. Check Screen voltage and Cathode Voltage, most likely low cathode voltage, norm is 150 w/video. Source of cathode voltage should be +200V. Screen voltage should be 200-400 V. Damon Brunger damon101@xxxxxxxxxxxxxx Telrad Electronic Services Ft Wayne, IN 46815 ----- Original Message ----- From: "Ndegwa, Amos" <A.NDEGWA@xxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Tuesday, May 21, 2002 3:39 AM Subject: [TechAssist] JVC G21T TV high power shutdown > > When switched On the TV goes straight to standby mode. When powered on thro' > remote, the screen goes on becomes very bright (no picture) and then then > shuts down. There is no picture though. The sound is not there either. The > timer led then starts flashing. Please advise on what could be faulty. The > voltage regulator IC S1854 with an input of 92V gives an output of about > 9.2 V. > > Thanks in advance > > Amos Ndegwa > ------------------------------------------ > To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html > To CHANGE your email address, click here: > http://www.tech-assist.org/change.html > ------------------------------------------ > ***NEW*** Tips Added Instantly!!!*** > Submit Repair Tips here: > http://www.tech-assist.org/secure/tip/ > ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.tech-assist.org/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/