Sounds like a bad Yoke to me, Larry Larry Eastman American TV & Electronics Crystal River, Fl. 34428 Ndegwa, Amos (ILRI) wrote: > This TV cannot turn on normally and I have to use a remote to have the EHT > which then goes off after a few seconds with an 'X-ray' error on the OSD. If > I disconnect the vertical deflection coil The TV does not go off and the > horizontal line is present. I had suspected the vertical IC LA 7840, but > replacing it did not change anything. There is one time I replaced the 5V > and 12 V regulators on the PSU section and the TV worked for about 3 minutes > and then went back to the initial problem. > > Please assist > > Amos Ndegwa > Compute Hardware Assistant > International Livestock Research Institute > Tel 2542630743 > www.ilri.cgiar.org > ------------------------------------------ > Submit A Repair Tip For Everyone Here: > http://www.tech-assist.org/secure/tip/main.html > ------------------------------------------ > To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html > To CHANGE your email address, click here: > http://www.techassist.net/forms/change.html > > > -- Larry Eastman American TV & Electronics Crystal River, Fl. http://www.tvjunkyard.com ------------------------------------------ Submit A Repair Tip For Everyone Here: http://www.tech-assist.org/secure/tip/main.html ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html