Check continuity between ic pins and the foil leading away from each pin. Chances are you have cracked the foil right around the pin when you unsoldered the IC. Hollis In a message dated 2/7/02 7:39:19 PM Eastern Standard Time, Seawarthog@xxxxxxx writes: << Subj: [TechAssist] JVC AV-35BP5 no Vertical Bow wow help please Date: 2/7/02 7:39:19 PM Eastern Standard Time From: Seawarthog@xxxxxxx Sender: techassist-bounce@xxxxxxxxxxxxx Reply-to: techassist@xxxxxxxxxxxxx To: techassist@xxxxxxxxxxxxx Hi Gang, Every once in a while you get a unit that refuses to be fixed no matter what you try. This unit is OK except there is no output from vertical chip. Uses a LA7845 vertical output. I have vertical drive going into pin 5 of 1 v. PP. There is no output. All voltages on chip are OK except pin 7 the pump up pin. It is at 29v. instead of 1 volt. I have swapped out every part except resistors. Checked resistors with out finding problem. Original problem was blown La7845 and the 3.3 ohm series B+ resistor. Replaced these and still no vertical deflection. Yoke measured bad on sencore so replaced it. What the heck could possibly cause vertical chip not to work. Voltage on IC are as follows pin 1-0 pin2-17v. pin3-29v. pin 4-2.0v. pin5-1.2v. with 1v. vertical ramp. pin6-29 v. pin7-29v. Open to any constructive criticism. Thanks in advance, Briant Reasonable Repair Rainy Seattle, WA. ------------------------------------------ Make your TechAssist database better! Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ ------------------------------------------ To UNSUBSCRIBE your email address, click here: mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe Or send a BLANK email with unsubscribe in the SUBJECT field to the address above. ----------------------- Headers --------- >> ------------------------------------------ Make your TechAssist database better! Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ ------------------------------------------ To UNSUBSCRIBE your email address, click here: mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe Or send a BLANK email with unsubscribe in the SUBJECT field to the address above.