Set came from my old employer Future Tech, where they couldn't fix it. I found the power/deflection board was broken completely into at the convergence amps area. A miserable attempt at running jumper wires had been made. I sent the board to PTS and they did a great job on it. I have gotten the convergence touched up, but the picture just isn't what it should be for this set. I downloaded the manual from Hitachi, but try as I may I haven't been able to get a good picture. I have to turn the brightness and contrast wide open, and still the picture is more "washed out" than it should be. I really think that the problem is in the adjusting, but I haven't had any success. Does anyone know what a good average value is in the set up menu for the sub brit. The manual doesn't show any values for page 01. The value presently in the menu is 85. from page 2 through page 18 all other values agree with the manual except Sub cir(page 3) Of instead of 1B and color(page 14) 58 instead of 40. The OSD seems bright and sharp enough, but I can't see it when the brightness and contrast are turned down as stated in the instructions. Any ideas and suggestions appreciated. TIA Walter Walter Wood United TV Service 501 Poplar St. P.O. box 602 Pulaski Tn. 38478 mailto:wwood_38478@xxxxxxxxx ----------------------------------------------------------------------------- This Email List is accessible to the general public through search engines. Remove: http://www.tech-assist.org/remove.htm Set Vacation mailto:ecartis@xxxxxxxxxxxxx?subject=set%20techassist%20vacation Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/