Lotsa possibilities. First check the electrolytic on the capstan motor to see if it is leaking and eating traces. Remove the reel belt and give the motor a spin to see if the rotor is dragging on the stator. Check the bearings for excessive side play. Could be that it needs a spacer washer or new bearings. If the motor is OK, run the vcr with a tapeless dummy to see if the capstan motor runs at all or if it runs weakly. If it runs weakly could be that the magnets have gotten weak and it just need another motor or that there is insufficient power or drive signal. If it doesnt run at all, the loading may not be completing or the mode switch may be malfuntioning. I would give the switch a squirt of contact cleaner to see if it made any difference. The mode switch is not available as a seperate part. You have to get the entire loading gear/motor assembly, which cost about $15. This is a good deal as the plastic gears tend to be worn out when the switch goes. If it runs OK with the dummy cassette, the problem may be with the reel block assembly, which can cause all sorts of reel brake and clutch problems. This is also replaced as a unit. If you replace that you should also replace the reel idler. Jerry Silverman Greentron Inc 4 Newland Ave Greenville SC 29609 864 232 3889 Fax 271 2080 mailto:greentron@xxxxxxx ----- Original Message ----- From: "MATT SHERER" <skoalman61821@xxxxxxxxx> To: "TECH ASSIST" <techassist@xxxxxxxxxxxxx> Sent: Saturday, January 19, 2002 2:13 AM Subject: [TechAssist] Hitachi VCR, capstan will not spin during play. > > Hitachi VCR > VT3400A > unit loads tape fine. When press play, capstan motor > will not turn. Sems to spin Ok when FFwd and REW. > Any help appreciated. > > Matt Sherer > Champaign, IL > > __________________________________________________ > Do You Yahoo!? > Send FREE video emails in Yahoo! Mail! > http://promo.yahoo.com/videomail/ > ------------------------------------------ > Make your TechAssist database better! > Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ > ------------------------------------------ > To UNSUBSCRIBE your email address, click here: > mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe > Or send a BLANK email with unsubscribe in the > SUBJECT field to the address above. > ------------------------------------------ Make your TechAssist database better! Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ ------------------------------------------ To UNSUBSCRIBE your email address, click here: mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe Or send a BLANK email with unsubscribe in the SUBJECT field to the address above.