I have had a simular symptom when someone tried to set up the convergence improperly, i had to clear the dcu and start from scratch, was the only way i could get it converged right. Ed Video Pro-Tech Mesa AZ ----- Original Message ----- From: "Jim Shupe" <jim@xxxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Wednesday, September 01, 2004 1:01 PM Subject: [TechAssist] Hitachi Model 50UX58B green convergence > Hi All.... > > > I have a 50UX58B that came to me with just the lower > right corner out of convergence. I changed the STK and > one resistor that had increased in value...but no > help. > > The green also looks thick and out of focus at that > corner, and appears to have hysterisis around the > corner point: that is, when I adjust the line(H or V) > toward alignment, it approaches, then will swing too > far past correct position. > > The degree of distortion appears to be related to > screen content as well...it moves in and out of the > corner with scene changes, etc. > > Has any one seen this or anything similar with this > set? > I talked to Hitachi and the tech said "sorry... no > silver bullet here." > > > TIA > Jim Shupe, CET > Yucca Valley, CA > > -------------------------------------------------------------------------- --- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ > ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/