The picture seems to vibrate.Better seen with my crosshatch generator. With the cross hatch pattern,the horizontal pattern lines all seem stable. The vertical lines are shaking ,or vibrating side to side.(they are the up-down lines ). Please note that S-VIDEO IS OK. Only noticable with RF cable inputs and the RCA line in jacks.So naturally I assumed the 3-comb filter board was bad.(This is the typical senereo when s-video is unaffected) Went to the Hitachi site and found a reference to "lines in picture" which said change three parts on the comb board: IX001,XX02,XX03: one IC,CP01081U and two "cans", BJ00141 and BJ00112. I ordered and installed them with no improvement. Since S-vid is OK must I assume this comb board is still bad or do I look elsewhere? I've emailed Alvie at Hitachi and await his assist again. He's been patient with me. Getting desperate here... Any Hitachi PTV Gurus out there? Phil Bader -- Philip Bader Jan Phyl TV Inc. (estab. 1976) 3420 Recker Hwy. Winter Haven, Fl. 33880 Fax (863) 299-8821 email: tjanphyl@xxxxxxxxxxxxxxx ***************************************************************************** The Tech Address Book: http://www.tech-assist.org/secure/tip/contact.html Add a Repair Tip Here, or Change/Remove your Email Address: http://www.tech-assist.org/secure/tip/main.htm Lost Password: http://www.tech-assist.org and select "Lost your Login Info?". Email Archives: //www.freelists.org/archives/techassist/